After using the Humminbird Bow 360 system for over 3 years, I’m convinced it is the most underrated piece of fishing equipment on the market. I honestly wouldn’t trade it for anything. I’d rather have smaller screens and a 360 than bigger screens without it.
With hundreds of 360 hours under my belt, I am very qualified in discussing the many benefits, as well as the limitations of this revolutionary sonar (pun intended). In this Humminbird Bow 360 review, you’ll see exactly why and how I use 360 to be a better and more efficient fisherman.
You are watching: humminbird 360 reviews
How it Works
360 Imaging is basically a rotating side imaging transducer. Where Side Imaging scrolls from top to bottom to create the image, 360 “scrolls” in a circle, creating an image of the water column around the boat.
Inside the transducer pod is several sonar imaging crystals rotating in a bath of oil. The rotation creates the circular sweep and software paints it onto the screen as an image. If you understand side imaging, you will quickly see how similar it is.
Installation & Items Needed
Installation of a Bow 360 system is extremely easy. The entire system consists of three components. There is the transducer pod on a shaft, the mounting bracket, and a GPS heading sensor.
The transducer pod is attached to a composite shaft, which attaches to the trolling motor via a locking bracket on an aluminum bracket. The teardrop collar above the pod must face straight forward in line with the center-line of the boat. The pod should be a few inches above the trolling motor housing, just enough to clear the prop.
There are two cables coming out of the shaft, one for power, the other is Ethernet. Take care when routing the cables along the trolling motor, there needs to be slack for deploying and retracting the trolling motor.
The GPS heading sensor tells the unit where to place the waypoints on the 360 sweep view. Mount the GPS puck in close vicinity to the 360 pod, and then connect it to the bow fish finder.
Once the pod and GPS puck are in good locations, and the cables are routed, you can connect it to your fish finder or network. The 360 can be run directly to the unit, or to the 5 Port Ethernet Switch. If you fish with a partner, a networked setup is perfect, as then both you and your back seat partner can view the 360 sweep.
Benefits of Bow 360
See all Around the Boat – The most obvious benefit to Bow 360 is being able to see the water column and lake bottom in all directions around the boat. Even better is it works best while stationary or moving slowly like you do when using the trolling motor. After fishing with a Bow 360 for a while, you will quite literally feel like you are fishing blind without it.
See Targets Before Reaching Them – With 360 on the bow, and using 360 Navigation with waypoints, you can slowly approach structure without having to drive over them and throw out a marker buoy, potentially spooking fish.
Line up Every Cast – With 360 Imaging, every cast can be productive. You don’t have to guess where the rock pile, grass line, or brush pile is, or search for it with your bait. You can line up every single cast and put your bait directly into the productive zones where fish live.
Follow Transition Lines – Points, ledges, humps, and reefs will all display a distinctive color change on the 360 sweep. Usually this is a combination of rising terrain and harder bottom, similar as you see on Side Imaging. 360 makes it dead simple to see you are in good casting position to whatever structure you are fishing.
See the Grass Line – Fishing submerged grass lines with 360 is fantastic. Just as you can see hardness changes, you see clearly see the weed and grass line around the boat. Turns, points, and holes in the grass become visible without you ever having to drive over the grass beds.
Reveal Irregularities – I am constantly surprised at the discoveries I make simply while fishing along the bank or ledge. I’ve found shell beds, bream beds, brush, and rock piles that I never would have known were there without 360.
Follow Bait and Schools of Fish – There have been numerous occasions where bait balls show up on the 360 sweep, and their movements can be tracked with every refresh. In open water you can see the bait as well as fish following. You can also literally watch fish move in and around brush piles by looking for the telltale white marks that appear and disappear.
See Beds – Bream beds (and the fish in them) show up extremely well on 360 Imaging. You can mark them using Side Imaging, then pull up to and fish them using the 360. There have been many occasions where I come across random colonies of bream beds on huge flats, or along the bank. These are always good spots to find big largemouth bass from Spring through Summer. The image below were Spotted bass beds next to brush piles.
Limitations of Bow 360
360 vs Panoptix
The most commonly compared product to the Humminbird 360 is the Garmin Panoptix. It is a ridiculous comparison in my opinion, as they are completely different types of sonar technology. Since they are the two most popular forward looking sonar systems being used, it is useful to discuss if you’re looking to buy one or the other.
Shallow Fishing: Bow 360 – When fishing shallow, you are typically making a high number of casts to specific targets and areas. For Panoptix to work it needs to be lined up with your target and it simply doesn’t make sense to spend all that time lining up the transducer to make a cast.
360 Imaging on the other hand, excels in shallow water. Whether you’re flipping and pitching or casting and cranking, just let the 360 sweep and you can hit every visible target and anything you can’t see that is revealed by the 360. Objects like wood, grass, and rocks are immediately visible to you and all you have to do is cast to them as you go.
Deep Fishing: Panoptix – The scenario where Panoptix works best is in deeper water, targeting specific pieces of structure. Things like rock piles, brush piles, humps, and points could all be fished very effectively with Panoptix. The main drawback being the transducer must be pointed toward the structure. You can sweep the transducer manually to help line up your casts. This forum post is an excellent example of how this might work for you.
Vertical Fishing: Panoptix – The most obvious use would be drop shotting. Assuming you have the downward facing Panoptix transducer, it will provide live sonar returns of your rig, fish within the cone, and how they are responding to the lure. The thing is, you can already do this with 2D sonar on fast scroll as proven by the professional bass tours. The only difference is 2D scrolls across the screen while Panoptix is a “live view”.
Ultra-Clear Water: Panoptix – Garmin really plays up the fact that Panoptix can show fish following your lure. It’s not clear how realistic of frequent this scenario would play out on the water. Most likely it would work best in clear waters where fish can see and follow your presentation. It could work well on spotted bass and smallmouth fisheries.
Grass Fishing: Bow 360 – As mentioned before, the 360 sweep provides constantly updating images of the grass around you. This information allows you to make precise casts along edges, pitch into holes, see turns, points, and isolated clumps that big fish love to hang around.
Versatility: Bow 360 – I am definitely biased, since I’ve only used 360, but I’ve tried to do thorough research and an honest comparison here. While Panoptix definitely has its uses, my feeling is that 360 is the more versatile tool for freshwater fishing.
Price: Bow 360 – The MSRP of Bow 360 is currently equal to the price of a PS21 Panoptix transducer, which is the most common for use on the trolling motor. For both systems you need a compatible unit capable of displaying the sonar.
Conclusion – Should you Get a Bow 360?
While the Humminbird Bow 360 is a relatively expensive accessory, it has been worth every penny. If you are seriously considering it but still unsure, the best you could do would be to spend half a day in the boat of someone who already has it. If you understand side and down imaging, you will quickly catch on to the power of 360 Imaging.
There is very little time wasted searching for the structure with casts or marker buoys. Knowing what was in front of me, and where, provides the ability to make precise casts every time. Bow 360 has been a game changer in my fishing, and I would feel like I was blind without one now.
Check Price on: pinkarmy.net